Sony HDCAM HDW-F900R Maintenance Manual page 328

Installation
3. Installing the FE/CTL head assembly
(1) Align the respective position-setting pins
with the reference holes of the FE/CTL head
assembly with the mechanical deck assembly,
and install the FE/CTL head assembly with
the three precision screws.
The standard tightening torque value :
_2
10 x 10 N.m (1 kgf.cm)
(2) Connect the harness of the FE/CTL head
assembly to the connector CN505 on the
MDC-13G board.
4. Cleaning FE/CTL head assembly
Clean the CTL head, FE head, tape cleaner and
tape guide using a cleaning cloth moistened with
cleaning fluid.
n
After cleaning, be sure to wipe the cleaning fluid
off the cleaned portions using a dry cleaning
cloth.
Adjustments after Replacement
5. Tape run adjustment
(Refer to Section 8-2-1.)
6. Video tracking adjustment
(Refer to Section 8-2-2.)
7. CTL head height adjustment
(Refer to Section 8-2-3.)
8. CTL head position adjustment
(Refer to Section 8-2-4.)
9. CUE/TC head position adjustment
(Refer to Section 8-2-8.)
7-56
FE/CTL head
assembly
Reference hole
Reference hole
Position-setting pin
Mechanical deck assembly
Precision screws
P1.4 x 3.5
Position-setting pin
CN505
MDC-13G board
HDW-F900R/V1 (E)