Sony HDCAM HDW-F900R Maintenance Manual page 154

LEVEL ADJ Display (Adjusting output signal level)
? 03 LEVEL ADJ
O
Y LEVEL
SYNC LEVEL
Pr LEVEL
Pb LEVEL
OUTPUT SELECT
Item
Y LEVEL
SYNC LEVEL
Pr LEVEL
Pb LEVEL
OUTPUT SELECT
* : RGB can be selected only when the Camcorder is used in the service mode.
SD LEVEL ADJ Display (Adjusting the down converter (SD OUT) output level)
(Require an optional HKDW-702/902R.)
? 04 O SD LEVEL ADJ
SD VBS LEVEL
SD VBS SETUP LVL:
Item
SD VBS LEVEL
SD VBS SETUP LVL
*1 : Displayed only when the HKDW-702/902R is installed.
*2 : If the format is set to 24PsF/23.98PsF when the HKDW-702 is installed or 24PsF when the HKDW-902R is installed, the setting is
displayed as "_ _".
4-38
: 0
: 0
: 0
: 0
: Y
Setting
(_99 to 99)
(_99 to 99)
(_99 to 99)
(_99 to 99)
*
Y/R/G/B/RGB
: 0
0%
Setting
(_99 to 99)
0%/7.5%
Function
Adjust the Y signal output level.
Adjust the sync signal output level.
Adjust the Pr signal output level.
Adjust the Pb signal output level.
Selects the video signal that is output from the TEST
OUT and the VBS/SDI OUT terminal. (Invalid when
the BARS signal is selected.)
(The Y-signal becomes the VBS signal when VBS is
selected in the SD REAR BNC OUT of the OUTPUT
SEL display (of the OPERATION menu) and SD is
selected in the TEST OUT SELECT.) The output
signal returns to the Y-signal without fail at power-on.
Function
Adjusts the VBS signal output level.
*2
Selects the setup level.
0% : Normal
7.5% : When an additional setup is required.
* * * * * 1
*2
HDW-F900R/V1 (E)