T Slider Assembly Replacement - Sony HDCAM HDW-F900R Maintenance Manual

7-33. T Slider Assembly Replacement

Replacement (Perform the part replacement according to the following
procedure.)
Removing the full top sensor assembly
Removing the T-Tension regulator assembly
Removing the pinch arm assembly
Removing the cassette stopper
Removing the T rail
Removing the T slider assembly
Installing the T slider assembly
Installing the T rail
Gear chain phase adjustment
Installing the cassette stopper
Installing the pinch arm assembly
Installing the T-tension regulator assembly
Installing the full top sensor assembly
Operation check
Cleaning the heads and tape running surface
Adjustment after replacement
Tape run adjustment
Note
Be careful not to touch the drum, tape guides and stationary heads all through the
replacement work.
Preparations
1. Turn off the main power.
2. Remove the front lid and outside panel assembly. (Refer to Section 1-4.)
3. Remove the cassette compartment. (Refer to Section 1-9.)
4. Check that the unit is in the unthreading-end state.
n
The stop washer is used to fix the T slider assembly.
Prepare a new stop washer (3-559-408-11) when replacing it.
Tools
. Torque cassette (FWD back tension) : J-6323-890-A
. Stop washer fastening tool :
. Cleaning cloth:
. Cleaning fluid:
. Torque screwdriver bit (for M1.4) :
. Torque screwdriver (for 3 kg) :
HDW-F900R/V1 (E)
J-6323-530-A
3-184-527-01
9-919-573-01
J-6325-110-A
J-6325-400-A
7-111