Slip Ring Assembly Replacement - Sony HDCAM HDW-F900R Maintenance Manual

7-5. Slip Ring Assembly Replacement

Replacement (Perform the part replacement according to the following
procedure.)
Removing connector from brush assembly
Removing the brush cover
Removing the brush assembly
Removing the slip ring assembly
Installing the slip ring assembly
Installing the brush assembly
Installing the brush cover
Connecting the connector to brush assembly
Notes
. When the brush assembly installation is completed with the following steps, the
height of the brushes and the contact pressure of brushes against the slip ring will
be automatically adjusted. No adjustment is required after replacement.
. Never attach cleaning fluid on the brush surface.
Preparations
Preparation on unit's side
1. Turn off the main power.
2. Remove the front lid and outside panel assembly. (Refer to Section 1-4.)
n
The brush assembly can be replaced when the cassette compartment attaches to the
unit.
Tools
. Torque screwdriver bit (for M2) :
. Torque screwdriver bit (for M1.4) : J-6325-110-A
. Torque screwdriver (for 3 kg) :
. Cleaning cloth :
. Cleaning fluid:
. Locking compound :
7-34
J-6325-380-A
J-6325-400-A
3-184-527-01
9-919-573-01
7-432-114-11
HDW-F900R/V1 (E)