Sony HDCAM HDW-F900R Maintenance Manual page 317

Removal
1. Removing the S-tension regulator
band assembly
(1) Remove the stop washer of the S-tension
regulator band assembly and remove it from
the shaft of link (S) assembly.
n
When removing the stop washer, be careful
not to apply an excessive force to the S-
tension regulator band assembly.
(2) Move the S5 tape guide of the S-tension
regulator arm in the direction of the arrow,
and remove the retainer shaft of the S-tension
regulator band assembly from the shaft of S-
tension regulator arm.
(3) While moving the (S) soft brake assembly out
with finger, remove the S-tension regulator
band assembly.
Installation
2. Cleaning S reel table
Clean the surface that contacts the tension
regulator band, of the S reel table using a cleaning
cloth moistened with cleaning fluid.
3. Installing the S-tension regulator band
assembly
(1) Install the new S-tension regulator band
assembly with its felt-side facing inside, by
reversing the steps of removal.
m
. When installing it, be careful not to bend
the S-tension regulator band assembly that
results in damage.
. Do not touch the felt surface of the S-
tension regulator band assembly hands.
Also never attach oil on the felt surface.
. Check that the (S) soft brake assembly is
pressing down the regulator band as shown.
(2) Attach the S-tension regulator band assembly
using a new stop washer.
n
When installing the stop washer, do not apply
excessive force to the S-tension regulator
band assembly.
HDW-F900R/V1 (E)
Stop washer
Surface of felt
S-Tension regulator
band assembly
Shaft of link (S)
assembly
(S) soft brake assembly
S reel table
S reel table
Band
(S) soft brake
assembly
Retainer shaft
Shaft of S-tension
regulator arm
S5 tape guide
Cleaning
7-45