Adjustment And Setting Items After Replacement Of Board; Ccd Unit; Board; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual
Color video camera
Hide thumbs
Also See for BVP-E30:
- Operation manual (38 pages) ,
- Manual (34 pages) ,
- Brochure & specs (14 pages)
Table of Contents
Advertisement
1-10. Adjustment and Setting Items After
Replacement of Board
When replacing the following boards, perform the adjust-
ments or settings referring to Section 5 “Electrical Align-
ment”
If no adjustment item is listed, no adjustment is required.
Board
Referring section
CCD unit
1-10-1. CCD Unit
TG-229 board
1-10-2. TG-229 Board
NR-72 board
1-10-3. NR-72 Board
VA-226 board
1-10-4. VA-226 Board
DPR-261 board
1-10-5. DPR-261 Board
AT-148 board
1-10-6. AT-148 Board
1-10-1. CCD Unit
Adjustment and Setting Items After CCD Unit is
Replaced
5-3-1. PA Gain Adjustment
5-4-3. SC Frequency Adjustment
4-7.
OHB file (Adjustment and Saving the OHB file)
1-10-2. TG-229 Board
Setting Items After Board is Replaced
Referring to Section 1-4, set the internal switches.
1-10-3. NR-72 Board
Setting Items After Board is Replaced
Referring to Section 1-4, set the internal switch.
1-16 (E)
1-10-4. VA-226 Board
The EEPROM (IC701) is mounted on the VA-226 board.
Perform the following adjustments, when this IC is
replaced, too.
Adjustment Items After Board or EEPROM is
Replaced
5-2-1. Black Balance Adjustment
5-2-2. Offset Adjustment
5-2-3. Flare Offset Adjustment
1-10-5. DPR-261 Board
The EEPROM (IC507) is mounted on the DPR-261 board.
Perform the following adjustments, when this IC is
replaced, too.
Adjustment Items After Board or EEPROM is
Replaced
5-4-1. Video Level Adjustment
5-4-2. TEST OUT Level Adjustment
1-10-6. AT-148 Board
The unique setting data that is set by user is written into
IC220 and IC221 on the AT-148 board.
Therefore, when these ICs were replaced with new ICs in
replacing the board or IC itself, the data set by user is lost,
and is returned to their factory-setting values.
Perform the following settings, when these ICs are re-
placed, too.
Setting Items After Board or FRAM is Replaced
. Reset the reference file, operator file and scene file.
(Refer to Section 4.)
. Replace lithium battery on the AT-148 board with a new
one, and reset date. (Refer to Sections 1-1-5 and 3-5.)
Hide quick links:
Advertisement
Table of Contents
