Upgrading (Ss-92G Board) - Sony HDCAM HDW-F900R Maintenance Manual

1-24-4. When the FL-272 Board is Used for
Version Upgrading (SS-92G Board)
Required tool : FL-272 board
(Sony part No. : J-6531-280-A)
SYSCON/SERVO ROM
(Sony part No. : J-6531-320-A)
1. Open the inside panel assembly. (Refer to Section 1-5.)
2. Remove the plug-in board assembly.
(Refer to Section 1-7.)
3. Remove the dust protection cover.
(Refer to Section 1-15-9.)
4. Insert the SYSCON/SERVO ROMs to the IC sockets
(IC8, IC9) on side A of the FL-272 board.
n
The IC numbers printed on the ROM label should
match with the IC numbers printed on the circuit
board.
5. Set the switch No.1 only of the DIP switch (S1) on the
FL-272 board to the ON position. (See Fig. 1.)
6. Short-circuit the solder slit (SL1) on side B of the FL-
272 board.
7. Turn off the power. Insert CN1 of the FL-272 board to
CN3 of the SS-92G board.
CN3
SS-92G board
1-62
Fig.1
DIP switch (S1)
E N
O P
No.1 pin
SYSCON/SERVO
ROM
IC9
IC8
CN1
FL-272 board
Fig.2
J/CAM
STUDIO
SL1
B side
(Soldering side)
8. Turn on the power. Erasing the software starts.
(After the diode D6 turns on, the diodes flash in the
order of D8→D4→D7.)
After that, writing the software starts.
(After the diode D2 turns on, the diodes flash in the
order of D8→D4→D7.)
9. When you confirm that the diode D5 on the FL-272
board lights, turn off the power.
10. Remove the FL-272 board from the SS-92G board.
11. Turn on the power and confirm that the system
initialization has ended with success and the system
starts up normally.
12. Upgrade the software version using Memory Stick.
(Refer to Section 1-24-2.)
HDW-F900R/V1 (E)