Sony HDCAM HDW-F900R Maintenance Manual page 27

Reinstallation
1. Close the board levers.
2. Insert the DVP board assembly into the groove on the
board holder in the direction of arrow A, and raise the
DVP board assembly in the direction of arrow B.
3. Connect the DVP board assembly and the MB-1096
board with the board-to-board connector.
Board lever
A
A
A
Board
holder (F)
MB-1096 board
HDW-F900R/V1 (E)
DVP board
assembly
B
DVP board assembly
DVP board
assembly
Board-to-board
connectors
4. Reinstall it by reversing the steps of disassembling.
n
When routing the two coaxial cables, pass them
through the three clamps and the groove on the SDI
shield plate, and connect the coaxial cable (green) to
CN201 on the TX-78 board, and the coaxial cable
(brown) to CN202.
Groove on the SDI shield plate Insert
a sheet of paper in the protected part.
TX-78 board
CN202
CN201
Coaxial cable (Green)
Clamps
Coaxial cable (Brown)
1-17