How To Exit Vtr Maintenance Mode; Tips On Operations - Sony HDCAM HDW-F900R Maintenance Manual

5. The SERVICE display appears.
S00.CONTENTS TOP
01.MENU SET
02.SP FUNC
03.VA ADJUST
04.CCD ADJUST
05.DCP ADJUST
06.RP DC OFFSET
07.MANUAL RPN
08.SD ADJUST
09.DR ADJUST
10.VTR MODE-7
6. Select S13 VTR MAINTE and press the rotary encoder.
7. The top menu of the VTR MAINTE appears.
VTR MAINTENANCE MENU
C0 : SERVO
C1 : RF
C2 : AUDIO
A0 : SERVO
A1 : RF
A2 : AUDIO
A4 : MECHANISM
A9 : OTHERS
n
Alternatively, the VTR Maintenance mode can be started as follows instead of steps 6 and 7.
6. Select S00. CONTENTS and press the rotary encoder.
(The arrow mark (→) appears next to the submenu.)
7. Rotate the rotary encoder to move the arrow mark (→) to 13. VTR MAINTE and press the rotary
encoder.

11-2-3. How to Exit VTR Maintenance Mode

Set the MENU ON/OFF switch on the inside panel to the OFF position. (Closing the lid turns off the
MENU ON/OFF switch automatically.)

11-2-4. Tips on Operations

. The function buttons for inserting a cassette tape, shooting, recording and playing back can be operated
from the displays on which the black square box (
not work as expected when the function buttons are operated while CHECK/ADJUST is in progress.
Note that the function buttons for inserting a cassette tape and other functions cannot be operated on the
displays without the black square box (
. There is no specific order of operation in the respective menu items; each menu item can be operated
independently. However, by performing all of the menu items in numerical order of menu number, the
unit can be thoroughly checked and adjusted by the built-in CHECK/ADJUST functions.
. Be sure to use the specified alignment tape and/or working tape in the CHECK/ADJUST items that
require a cassette tape to be used.
HDW-F900R/V1 (E)
CHECK
CHECK
CHECK
ADJUST
ADJUST
ADJUST
ADJUST
ADJUST
) appears at the top right. Note that operation may
) displayed at the top right.
11-3