Sony HDCAM HDW-F900R Maintenance Manual page 308

4. Removing the slip ring assembly
(1) Remove the two screws fixing the slip ring
assembly.
(2) While removing the connector on the UDR-
32 board, remove the slip ring assembly
together.
Installation
5. Installing the slip ring assembly
n
When the upper drum assembly is not going to be
replaced, remove the locking compound that has
adhered to the two screws that fix the upper drum
slip ring assembly.
(1) Place the connector of the new slip ring
assembly in front of the connector on the
UDR-32 board of the upper drum assembly.
While installing the slip ring assembly to the
drum shaft, connect the connectors.
(2) While pressing the slip ring assembly to the
upper drum, install the slip ring assembly
with the two screws that are coated with the
locking compound with equal torque. Then
tighten the screws with torque screwdriver.
The standard tightening torque value :
_2
10 x 10 N.m (1 kgf.cm)
7-36
B2 x 4
Connector
Connectors
Slip ring assembly
UDR-32 board
B2 x 4
Screws coated with
locking compound
Slip ring assembly
UDR-32 board
HDW-F900R/V1 (E)