Sony HDCAM HDW-F900R Maintenance Manual page 381

9. Installing the S rail
(1) Insert the claw on the rear of the S rail to the
bottom of the S plate assembly and lower the
front of the S rail in the direction of A.
(2) Insert the pin of the S gear assembly into the
hole of the S link assembly and fix it with the
new stop washer.
n
Do not apply excessive force to the S gear
assembly when installing the stop washer.
(3) Install the S rail with the six precision screws.
The standard tightening torque value :
10 x 10 _2
N.m (1 kgf.cm)
10. Gear chain phase adjustment
(Refer to Section 8-1-8.)
11. Installing the cassette stopper
Install the cassette stopper with the precision
screw.
(Refer to Section 7-23.)
12. Installing the threading arm assembly
Install the threading arm assembly with the new
stop washer.
(Refer to Section 7-30.)
13. Installing the S-tension regulator
assembly replacement
Install the S-tension regulator assembly with the
two precision screws.
(Refer to Section 7-21.)
14. Installing the S-tension regulator band
assembly
Install the S-tension regulator band assembly with
the new stop washer.
(Refer to Section 7-8.)
15. Installing the full top sensor assembly
Install the full top sensor assembly with the
precision screw.
(Refer to Section 7-16.)
HDW-F900R/V1 (E)
S slider assembly
Stop washer
Precision screw
P1.4 x 3.5
Hole of S link
assembly
S rail
A
Precision
screw
P1.4 x 3.5
Precision screws
P1.4 x 3.5
Precision screw
P1.4 x 3.5
Pin of
S gear
assembly
S plate assembly
Claw of S rail
7-109