Procedure; Ccd Unit Replacement - Sony HDCAM HDW-F900R Maintenance Manual

6-1. CCD Unit and its Components Parts
Replacement Procedure

6-1-1. CCD Unit Replacement

Overview
Removing the Front Assembly
Removing the Filter Knob
Removing the CCD Unit
Installing the CCD Unit
Installing the Filter Knob
Attaching the Front Assembly
Adjustment after Replacement
8-2-1. Tape Run Adjustment
9-2. VCO Frequency Adjustment
9-6. Black Offset Adjustment
Removal
1. Removing the front assembly
(1) Remove the outside panel assembly.
(Refer to Section 1-4.)
(2) Open the inside panel assembly.
(Refer to Section 1-5.)
(3) Disconnect the harness from the connector (CN3) on
the DCP-43 board.
(4) Disconnect the harness and flexible card wire from the
connectors (CN1, CN9, CN10) on the DR-614 board.
(5) Remove the one screw (PSW2 x 5) and disconnect the
DCP holder (F) from the CHB stay.
(6) Remove the four screws (B3 x 10). While removing
the front assembly, disconnect harness from the
connector (CN502, CN503) on the IFA-19G board.
HDW-F900R/V1 (E)
Section 6
Parts Replacement
DCP holder (F)
Front assembly
B3 x 10
B3 x 10
Flexible card wire
CHB stay
PSW 2x5
CN1
CN503
CN9
IFA-19G
CN10
DR-614 board
DCP-43 board
CN3
CN502
board
6-1