Sony HDCAM HDW-F900R Maintenance Manual page 368

Installation
3. Cleaning the mount shaft
Clean the mount shaft and bearing using a
cleaning cloth moistened with cleaning fluid.
4. Applying oil to the mount shaft
Apply a 1/2 drop of oil to the mount shaft and
bearing respectively.
5. Installing the pinch arm assembly
(1) While running the cam groove of the arm
assembly through the bearing, install the
mount shaft to the pinch arm assembly mount
shaft.
(2) Fix the new stop washer.
6. Installing the T-tension regulator
assembly
Fix the T-tension regulator assembly with the
new stop washer. (Refer to Section 7-22.)
7. Cleaning the pinch roller assembly
(1) After installing it, clean the pinch roller
assembly surface using a cleaning cloth
moistened with cleaning fluid.
(2) Rotate the manual eject gear (A) using
phillips screwdriver clockwise until the
unthreading-end state is established.
Adjustments after Replacement
8. Tape run adjustment
(Refer to Section 8-2-1.)
9. Capstan add-on recording adjustment
(Refer to Section 10-5-3.)
7-96
Pinch roller assembly
(Cleaning after installation)
Cam groove of
arm assembly
Bearing of F link assembly
(Apply oil after cleaning)
Pinch arm assembly
Stop washer
Mount shaft
(Apply oil after cleaning)
HDW-F900R/V1 (E)