Sony HDCAM HDW-F900R Maintenance Manual page 537

If the message "INCOMPLETE" is displayed
If the message "INCOMPLETE" is displayed while the respective
adjustment menus are in progress from A11 to A17, check the follow-
ing items in order.
. When the alignment tape is used, check if it is the specified (HR5-
1A Part No. 8-960-076-01) or not.
→ If it is not the specified tape, use the specified tape and imple-
ment the adjustment.
. Perform drum (video head) cleaning referring to n of
Section 11-2-2 C11: PB CH CONDITION and n of C12 :
REC CH CONDITION. When cleaning is already implemented, it is
not necessary.
. If the message "INCOMPLETE" is displayed while executing any
menu other than A17, implement the automatic adjustment using the
A17 menu.
If the message "INCOMPLETE" is displayed even after the above
adjustments are performed, check the following possible causes.
. Defective adjustment of the servo system, or servo circuit is defec-
tive.
→ Servo System Re-Alignment (A0 : SERVO ADJUST)
→ Servo System check (C0 : SERVO CHECK)
. The playback heads inside the drum assembly were worn out.
→ If required, replace the upper drum assembly or drum assembly.
. Defective adjustment of tape run system, or part mounting is
defective.
→ Re-adjustment or re-installation
. EQ-88G board is defective.
. Drum assembly is defective.
. Brush/slip ring assembly is defective or its mounting is defective.
→ Replacement or re-installation
. Connection of the flexible board (between the MDR-14G board and
the EQ-88G board) is defective.
HDW-F900R/V1 (E)
11-37