Operation Menu - Sony HDCAM HDW-F900R Maintenance Manual

4-4. OPERATION Menu

n
When the range of setting is surrounded by parenthesis ( ) in the setting column, the setup value is the
relative value. The range of setting in parenthesis ( ) can be different from what shown in the manual
depending on the setting in the layer lower than this menu.
OUTPUT SEL Display (Setting the Output Signal)
? 01 O OUTPUT SEL
HD SDI OUT
SD REAR BNC OUT :
TEST OUT SELECT :
DOWN CON MODE
VF Y 2-3PULLDOWN:
Item
HD SDI OUT
SD REAR BNC OUT
TEST OUT SELECT
DOWN CON MODE
VF Y 2-3PULLDOWN
*1 : The HD-SDI OUT terminal on the side of HDW-F900R can be used as the VBS/SDI output when the HKDW-702/902R is installed.
*2 : Displayed only when the HKDW-702/902R is installed.
*3 : If a value other than Y (R, G, B) is selected for the "OUTPUT SELECT" item, a single-channel monochrome signal is output even
when VBS or SDI is selected for "SD REAR BNC OUT".
*4 : MARKER or ZEBRA is not output to the TEST OUT terminal when CROP is selected for TEST OUT SELECT: SD.
*5 : If the format is set to 24PsF/23.98PsF when the HKDW-702 is installed or 24PsF when the HKDW-902R is installed, the setting is
displayed as "_ _".
*6 : The SD output is not possible if the format is set to 24PsF/23.98PsF when the HKDW-702 is installed or 24PsF when the HKDW-
902R is installed. (When the SD output is selected, the output turns OFF.)
*7 : Displayed only when the HKDW-902R is installed.
HDW-F900R/V1 (E)
: ON
OFF
HD
: CROP
OFF
Setting
OFF/ON
OFF/VBS/SDI
HD/SD
SQEZE/LETTR/CROP
OFF/ON
Function
Sets the output signal from the HD SDI OUT
*1
terminal.
Selects the output signal from the VBS/SDI
OUT terminal. *1, *2, *3, *5
VBS : VBS signal
SDI : SDI signal
OFF : No output signal
Selects the output signal from the TEST OUT
*6
terminal.
Selects aspect ratio at down-conversion.
SQEZE : Squeeze
The HD video signal is converted to
the SD signal with the aspect ratio
of 16 : 9 as it is. (16 : 9)
LETTR : Letterbox
The HD video signal having aspect
ratio of 16:9 is inserted into the
picture frame of 4 : 3 as it is and is
converted to the SD signal. (4 : 3)
The black level bars are inserted in
the top and bottom of the SD output
video signal.
CROP : Edge crop
The video signal area occupying the
aspect ratio of 4 : 3 is cut out from
the HD video signal and is
converted to the SD signal. (4 : 3)
Selects the Y signal converted into the VF signal as a
result of the 2-3 pull-down correction when 23.98PsF
or 24PsF is selected for the format.
*2, *4, *5
*7
4-5