Sony HDCAM HDW-F900R Maintenance Manual page 239

8. Removing the CN-2871 board
(1) Remove the four screws (P2 x 4) and remove the CHB
assembly.
(2) Remove the BI flexible protection sheet.
(3) Disconnect the flexible card wires from the connectors
(CN2, CN3, CN4) on the CN-2871 board.
n
Life of flexible card wire will be significantly short-
ened if it is folded. Be very careful not to fold the
flexible card wire.
(4) Remove the two solderings with the CCD ground sheet
(IN).
(5) Remove the two screws (PSW2 x 5), and remove the
CN-2871 board.
9. Attaching
Attach the boards by reversing the step 1 to 8.
6. RP-131
CN1
PSW 2 x 5
PSW 2 x 5
Connected by
soldering
PSW 2 x 5
CN101
CCD ground sheet
(OUT)
Connected by
soldering
HDW-F900R/V1 (E)
board
7. PA-340 board
CN1
CN104
CN103
Connected by
soldering
CN102
CHB stay
Flexible card wires
CCD ground
sheet (IN)
Connected
CN3
by soldering
CN1
CN4
CN2
8. CN-2871 board
Flexible card wire
CN2
5. TG-256
P2 x 4
CN1
P2 x 4
CN3
Connected by
soldering
4. DR-614 board
BI flexible protection sheet
PSW 2 x 5
PSW 2 x 5
board
PSW 2 x 5
Board spacers
PSW 2 x 5
6-7