Sony HDCAM HDW-F900R Maintenance Manual page 539

5. The results for the all the channels are displayed.
When the adjustment ends successfully :
The message "COMPLETE" appears for all the channels.
When the adjustment fails :
The message "ERR" appears for the channel with an error.
m
. If "TIME OVER ERR" appears, check the input signal and
perform the adjustment again.
. If "INPUT OVER ERR" appears, check the signal level since
the level of the signal being input may be too large.
. If "INPUT UNDER ERR" appears, check the signal level since
the level of the signal being input may be too small.
. If "NO INPUT ERR" appears, check the input signal since the
signal may not be input correctly.
A21 : AUDIO D/A ADJUST
Adjusts the audio D/A error correction value with reference to the
internal SG.
1. Select "A21 : AUDIO D/A ADJ" on the AUDIO ADJUST
MODE display, and press the rotary encoder.
2. Select "YES" for ADJUST START, and press the rotary encoder.
3. Turn the CH-1 AUDIO LEVEL knob so that the CH-1 output
level becomes 0 dBm ± 0.05 dB.
4. Turn the CH-2 AUDIO LEVEL knob so that the CH-2 output
level becomes 0 dBm ± 0.05 dB.
5. Select "YES" for COMPLETE ADJUSTING?, and press the
rotary encoder.
When the adjustment ends successfully :
The message "COMPLETE" appears.
n
If "NO" is selected, the data adjusted this time becomes invalid,
and the previously adjusted data becomes valid.
HDW-F900R/V1 (E)
AUDIO ADJUST MODE
A20:AUDIO A/D ADJUST
CH1:COMPLETE
CH2:COMPLETE
CH3:COMPLETE
CH4:COMPLETE
AUDIO ADJUST MODE
A21:AUDIO D/A ADJUST
ADJUST START
→
YES NO
AUDIO ADJUST MODE
A21:AUDIO D/A ADJUST
COMPLETE ADJUSTING?
→
YES NO
TURN CH1 AND CH2 AU
LEVEL KNOBS SO THAT CH1
AND CH2 OUTPUT LEVELS
BECOME 0dBm +-0.05dB
AUDIO ADJUST MODE
A21:AUDIO D/A ADJUST
COMPLETE
→
YES NO
11-39