Sony HDCAM HDW-F900R Maintenance Manual page 357

Installation
4. Cleaning the reel shaft
Clean the reel shaft using a cleaning cloth
moistened with cleaning fluid.
5. Cleaning the reel table
(1) Clean the surface of a reel table, that contacts
the tension regulator band assembly using a
cleaning cloth moistened with cleaning fluid.
(2) Wipe the bottom surface of the reel table with
dry cloth.
6. Installing the reel table (1)
While pressing the soft brake arm out of their
position with finger, install the reel table to the
reel shaft.
7. Reel table height adjustment
(Refer to Section 8-1-1.)
8. Installing the reel table (2)
(1) Install the poly-washers that are not used in
step 7 (becoming extra poly-washers), to the
reel shaft.
(2) Fix the reel table with the new stop washer.
(3) Move the reel table up and down to confirm
that there is a play. If there is no play, remove
a single piece of poly-washer from the top of
the reel table.
9. Installing the S-tension regulator band
assembly (Only when S reel table
assembly is replaced)
(Refer to Section 7-8.)
10. Installing the T-tension regulator band
assembly (Only when T reel table
assembly is replaced)
(Refer to Section 7-9.)
11. Operation check
While pressing the soft brake out of their position
with finger, rotate the reel to confirm that the reel
table and the S/T idler assemblies rotate smooth-
ly.
HDW-F900R/V1 (E)
Stop washer
Poly-washer
(1 or 2 washers)
S reel table
assembly
Reel shaft
(cleaning)
S soft brake
Poly-washer
S idler assembly
T idler assembly
Bottom surface
(wipe with dry cloth.)
Contact surface
(cleaning)
. S reel table
assembly
Stop washer
Poly-washer
(1 or 2 washers)
T reel table
assembly
Reel shaft
T soft brake
(cleaning)
Poly-washer
7-85