Igmp Static-Group - HP 6125G Command Reference Manual

Description
Use igmp startup-query-interval to configure the startup query interval on the current interface.
Use undo igmp startup-query-interval to restore the default.
By default, the startup query interval is 1/4 of the IGMP general query interval.
Related commands: igmp timer query and startup-query-interval.
Examples
# Set the startup query interval to 5 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp startup-query-interval 5

igmp static-group

Syntax
igmp static-group group-address [ source source-address ]
undo igmp static-group { all | group-address [ source source-address ] }
View
Interface view
Default level
2: System level
Parameters
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
source-address: Multicast source address.
all: Removes all static multicast groups that the current interface has joined.
Description
Use igmp static-group to configure the current interface to be a statically connected member of the
specified multicast group or multicast source and group.
Use undo igmp static-group to restore the default.
By default, an interface is not a static member of any multicast group or multicast source and group.
If the specified multicast address is in the SSM multicast address range, you must specify a multicast
source address at the same time. Otherwise, IGMP routing table entries cannot be established. No such
a restriction exists if the specified multicast group address is not in the SSM multicast address range.
To configure a VLAN interface as a static member of a multicast group or multicast source and group,
execute the igmp static-group command on the VLAN interface, and configure the igmp-snooping
static-group command on the member ports of the corresponding VLAN.
Related commands: igmp-snooping static-group.
Examples
# Configure VLAN-interface 100 to be a statically connected member of multicast group 224.1.1.1.
<Sysname> system-view
[Sysname] interface vlan-interface 100
81