Multicast Routing-Enable; Reset Multicast Forwarding-Table - HP 6125G Command Reference Manual

Parameters
None
Description
Use multicast longest-match to configure the device to select the RPF route using longest match.
Use undo multicast longest-match to restore the default.
By default, the device selects the route with the highest priority as the RPF route.
Examples
# Configure the device to select the RPF route based on the longest match principle.
<Sysname> system-view
[Sysname] multicast longest-match

multicast routing-enable

Syntax
multicast routing-enable
undo multicast routing-enable
View
System view
Default level
2: System level
Parameters
None
Description
Use multicast routing-enable to enable IP multicast routing.
Use undo multicast routing-enable to disable IP multicast routing.
By default, IP multicast routing is disabled.
You must enable IP multicast routing before you can use other Layer 3 multicast commands.
The device does not forward any multicast packets before IP multicast routing is enabled.
Examples
# Enable IP multicast routing.
<Sysname> system-view
[Sysname] multicast routing-enable

reset multicast forwarding-table

Syntax
reset multicast forwarding-table { { source-address [ mask { mask | mask-length } ] | group-address
[ mask { mask | mask-length } ] | incoming-interface { interface-type interface-number | register } } * |
all }
55