incoming-interface: Displays PIM routing entries that contain the specified interface as the incoming
interface.
interface-type interface-number: Specifies an interface by its type and number.
register: Specifies the register interface. This keyword is valid only if mode-type is not specified or is sm.
outgoing-interface: Displays PIM routing entries, where the outgoing interface is the specified interface.
include: Displays PIM routing entries, where the outgoing interface list includes the specified interface.
exclude: Displays PIM routing entries, where the outgoing interface list excludes the specified interface.
match: Displays PIM routing entries, where the outgoing interface list includes only the specified
interface.
mode mode-type: Specifies a PIM mode, where mode-type can have the following values:
•
dm: Specifies PIM-DM.
sm: Specifies PIM-SM.
•
ssm: Specifies PIM-SSM.
•
flags flag-value: Displays PIM routing entries that contains the specified flags. The values of flag-value
and their meanings are as follows:
2msdp: Specifies PIM routing entries to be contained in the next SA message to notify an MSDP
•
peer.
act: Specifies PIM routing entries that have been used for routing data.
•
del: Specifies PIM routing entries scheduled to be deleted.
•
•
exprune: Specifies PIM routing entries that contain outgoing interfaces pruned by other multicast
routing protocols.
ext: Specifies PIM routing entries that contain outgoing interfaces provided by other multicast
•
routing protocols.
loc: Specifies PIM routing entries on the devices that directly connect to the same subnet as the
•
multicast source.
msdp: Specifies PIM routing entries obtained from MSDP SA messages.
•
niif: Specifies PIM routing entries that contain unknown incoming interfaces.
•
•
nonbr: Specifies PIM routing entries with PIM neighbor searching failure.
rpt: Specifies PIM routing entries on RPT branches where (S, G) prunes have been sent to the RP.
•
spt: Specifies PIM routing entries on the SPT.
•
•
swt: Specifies PIM routing entries in the process of RPT-to-SPT switchover.
wc: Specifies wildcard routing entries.
•
fsm: Displays the information of the state machine.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
114