Register-Whole-Checksum (Pim View); Reset Pim Control-Message Counters - HP 6125G Command Reference Manual
Ip multicast
Hide thumbs
Also See for 6125G:
- Command reference manual (410 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Examples
# Set the register suppression time to 70 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] register-suppression-timeout 70
register-whole-checksum (PIM view)
Syntax
register-whole-checksum
undo register-whole-checksum
View
PIM view
Default level
2: System level
Parameters
None
Description
Use register-whole-checksum to configure the router to calculate the checksum based on the entire
register message.
Use undo register-whole-checksum to restore the default.
By default, the checksum is calculated based on the header in the register message.
Related commands: register-policy and register-suppression-timeout.
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] register-whole-checksum
reset pim control-message counters
Syntax
reset pim control-message counters [ interface interface-type interface-number ]
View
User view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Resets the PIM control message counter on a particular
interface. If no interface is specified, this command resets PIM control message counters on all interfaces.
137
Advertisement
Table of Contents
