Peer Route-Policy (Ipv6 Mbgp Address Family View) - HP 6125G Command Reference Manual

peer route-policy (IPv6 MBGP address family view)

Syntax
peer { ipv6-group-name | ipv6-address } route-policy route-policy-name { import | export }
undo peer { ipv6-group-name | ipv6-address } route-policy route-policy-name { import | export }
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
route-policy-name: Specifies a routing policy name, a case-sensitive string of 1 to 63 characters.
import: Applies the routing policy to routes received from the IPv6 MBGP peer or the peer group.
export: Applies the routing policy to routes advertised to the IPv6 MBGP peer or the peer group.
Description
Use peer route-policy to apply a routing policy to routes incoming from or outgoing to an IPv6 MBGP
peer or peer group.
Use undo peer route-policy to remove the configuration.
By default, no routing policy is applied to the routes incoming from or outgoing to an IPv6 MBGP peer
or peer group.
The if-match interface clause in the routing policy referenced by the peer route-policy command is not
applied.
For more information, see Layer 3—IP Routing Command Reference.
Examples
# Apply the routing policy test-policy to routes received from the IPv6 MBGP peer group test.
<Sysname> system-view
[Sysname] route-policy test-policy permit node 10
[Sysname-route-policy] if-match cost 10
[Sysname-route-policy] apply cost 65535
[Sysname-route-policy] quit
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test route-policy test-policy import
399