Dscp (Mld View) - HP 6125G Command Reference Manual

Table 64 Command output
Field
Interface group report information
Total 1 MLD SSM-mapping Group reported
Group
Uptime
Expires
Last reporter
Group mode
Source list(Total 1 source)
Source
Last-listener-query-counter
Last-listener-query-timer-expiry

dscp (MLD view)

Syntax
dscp dscp-value
undo dscp
View
MLD view
Default level
2: System level
Parameters
dscp-value: Specifies the DSCP value for MLD messages, in the range of 0 to 63.
Description
Use dscp to set the DSCP value for MLD messages.
Use undo dscp to restore the default.
The default DSCP value in MLD messages is 48.
Examples
# Set the DSCP value to 63 for MLD messages.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] dscp 63
Description
IPv6 multicast group information created based on MLD SSM
mappings on the interface.
One MLD SSM mapping multicast group was reported.
IPv6 multicast group address.
Length of time since the IPv6 multicast group was reported.
Remaining time of the IPv6 multicast group, where "off" means
that the group never times out.
IPv6 address of the host that last reported membership for this
group.
IPv6 multicast sources filter mode.
IPv6 multicast source list (one IPv6 multicast source).
IPv6 multicast source address.
Number of MLD last listener queries sent.
Remaining time of the MLD last listener query timer, where "off"
means that the timer never expires.
280