Jp-Pkt-Size (Ipv6 Pim View); Jp-Queue-Size (Ipv6 Pim View) - HP 6125G Command Reference Manual

Examples
# Set the global value of the join/prune timeout time to 280 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] holdtime join-prune 280

jp-pkt-size (IPv6 PIM view)

Syntax
jp-pkt-size packet-size
undo jp-pkt-size
View
IPv6 PIM view
Default level
2: System level
Parameters
packet-size: Maximum size of each join/prune message in bytes, with an effective range of 100 to
64000.
Description
Use jp-pkt-size to configure the maximum size of each join/prune message.
Use undo jp-pkt-size to restore the default.
By default, the maximum size of each join/prune message is 8100 bytes.
If IPv6 PIM snooping–enabled switches are deployed in the IPv6 PIM network, be sure to set a value no
greater than the IPv6 path MTU for the maximum size of each join/prune message on the receiver-side
edge IPv6 PIM devices.
Related commands: jp-queue-size.
Examples
# Set the maximum size of each join/prune message to 1500 bytes.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] jp-pkt-size 1500

jp-queue-size (IPv6 PIM view)

Syntax
jp-queue-size queue-size
undo jp-queue-size
View
IPv6 PIM view
Default level
2: System level
332