Pim Ipv6 State-Refresh-Capable; Pim Ipv6 Timer Graft-Retry - HP 6125G Command Reference Manual
Ip multicast
Hide thumbs
Also See for 6125G:
- Command reference manual (410 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 sm
pim ipv6 state-refresh-capable
Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim ipv6 state-refresh-capable to enable the state refresh feature on the interface.
Use undo pim ipv6 state-refresh-capable to disable the state refresh feature.
By default, the state refresh feature is enabled.
Related commands: state-refresh-hoplimit, state-refresh-interval, and state-refresh-rate-limit.
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim ipv6 state-refresh-capable
pim ipv6 timer graft-retry
Syntax
pim ipv6 timer graft-retry interval
undo pim ipv6 timer graft-retry
View
Interface view
Default level
2: System level
Parameters
interval: Graft retry period in seconds, with an effective range of 1 to 65,535.
341
Advertisement
Table of Contents
