Mld-Snooping Special-Query Source-Ip - HP 6125G Command Reference Manual

Description
Use mld-snooping source-deny to enable IPv6 multicast source port filtering.
Use undo mld-snooping source-deny to disable IPv6 multicast source port filtering.
By default, IPv6 multicast source port filtering is disabled.
This command works in both MLD snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
Examples
# Enable source port filtering for IPv6 multicast data on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping source-deny

mld-snooping special-query source-ip

Syntax
mld-snooping special-query source-ip { ipv6-address | current-interface }
undo mld-snooping special-query source-ip
View
VLAN view
Default level
2: System level
Parameters
ipv6-address: Specifies an IPv6 link-local address as the source IPv6 address of MLD
multicast-address-specific queries.
current-interface: Specifies the source IPv6 link-local address of the VLAN interface of the current VLAN
as the source IPv6 address of MLD multicast-address-specific queries. If the current VLAN interface does
not have an IPv6 address, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used as the source
IPv6 address of MLD multicast-address-specific queries.
Description
Use mld-snooping special-query source-ip to configure the source IPv6 address of MLD
multicast-address-specific queries.
Use undo mld-snooping special-query source-ip to restore the default.
By default,
FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD snooping is enabled for the VLAN.
Related commands: mld-snooping enable.
Examples
# In VLAN 2, enable MLD snooping and specify FE80:0:0:1::1 as the source IPv6 address of MLD
multicast-address-specific queries.
<Sysname> system-view
[Sysname] mld-snooping
the source IPv6 address of MLD
244
multicast-address-specific queries is