Require-Router-Alert (Mld View); Reset Mld Group - HP 6125G Command Reference Manual

Related commands: version.
Examples
# Set the MLD version to MLDv2 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld version 2

require-router-alert (MLD view)

Syntax
require-router-alert
undo require-router-alert
View
MLD view
Default level
2: System level
Parameters
None
Description
Use require-router-alert to globally configure the device to discard MLD messages without the
Router-Alert option.
Use undo require-router-alert to restore the default.
By default, the device does not check the Router-Alert option. That is, it forwards all received MLD
messages to the upper layer protocol for processing.
Related commands: mld require-router-alert and send-router-alert.
Examples
# Configure the device to discard MLD messages without the Router-Alert option.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] require-router-alert

reset mld group

Syntax
reset mld group { all | interface interface-type interface-number { all | ipv6-group-address [ prefix-length ]
[ ipv6-source-address [ prefix-length ] ] } }
View
User view
Default level
2: System level
295