Reflect Between-Clients (Mbgp Address Family View); Reflector Cluster-Id (Mbgp Address Family View) - HP 6125G Command Reference Manual

reflect between-clients (MBGP address family view)

Syntax
reflect between-clients
undo reflect between-clients
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
None
Description
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route
reflector are fully meshed, you must disable route reflection between clients to reduce routing costs.
Related commands: reflector cluster-id and peer reflect-client.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] undo reflect between-clients

reflector cluster-id (MBGP address family view)

Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
cluster-id: Specifies a route reflector by its cluster ID, in the range of 1 to 4294967295.
ip-address: Specifies a route reflector by its IP address, in the format of an IP address.
Description
Use reflector cluster-id to configure the cluster ID of the route reflector.
213