Pim Triggered-Hello-Delay; Probe-Interval (Pim View) - HP 6125G Command Reference Manual
Ip multicast
Hide thumbs
Also See for 6125G:
- Command reference manual (410 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Use undo pim timer join-prune to restore the default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer join-prune 80
pim triggered-hello-delay
Syntax
pim triggered-hello-delay interval
undo pim triggered-hello-delay
View
Interface view
Default level
2: System level
Parameters
interval: Maximum delay in seconds between hello messages, with an effective range of 1 to 60.
Description
Use pim triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim triggered-hello-delay to restore the default.
By default, the maximum delay between hello messages is 5 seconds.
Examples
# Set the maximum delay between hello messages to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim triggered-hello-delay 3
probe-interval (PIM view)
Syntax
probe-interval interval
undo probe-interval
View
PIM view
Default level
2: System level
134
Advertisement
Table of Contents
