Mld-Snooping Proxying Enable - HP 6125G Command Reference Manual

end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094.
Description
Use mld-snooping overflow-replace to enable the IPv6 multicast group replacement function on the
current port.
Use undo mld-snooping overflow-replace to disable the IPv6 multicast group replacement function.
By default, the IPv6 multicast group replacement function is disabled.
This command works in both MLD snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
If you do not specify any VLAN when using this command in Layer 2 Ethernet interface view or Layer 2
aggregate interface view, the command takes effect for all VLANs that the interface belongs to. If you
specify one or multiple VLANs, the command takes effect for the specified VLANs that the interface
belongs to.
Related commands: overflow-replace.
Examples
# Enable the IPv6 multicast group replacement function on GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping overflow-replace vlan 2

mld-snooping proxying enable

Syntax
mld-snooping proxying enable
undo mld-snooping proxying enable
View
VLAN view
Default level
2: System level
Parameters
None
Description
Use mld-snooping proxying enable to enable the MLD snooping proxying function in a VLAN.
Use undo mld-snooping proxying enable to disable the MLD snooping proxying function in a VLAN.
By default, MLD snooping proxying is disabled in all VLANs.
Before you configure this command in a VLAN, enable MLD snooping for the VLAN.
Related commands: mld-snooping enable.
Examples
# Enable MLD snooping and then MLD snooping proxying in VLAN 2.
<Sysname> system-view
239