Pim Dm - HP 6125G Command Reference Manual
Ip multicast
Hide thumbs
Also See for 6125G:
- Command reference manual (410 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim bsr-boundary to configure a PIM domain border, namely, a bootstrap message boundary.
Use undo pim bsr-boundary to remove the configured PIM domain border.
By default, no PIM domain border is configured.
Related commands: c-bsr and multicast boundary.
Examples
# Configure VLAN-interface 100 as a PIM domain border.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim bsr-boundary
pim dm
Syntax
pim dm
undo pim dm
View
Interface view
Default level
2: System level
Parameters
None
Description
Use pim dm to enable PIM-DM.
Use undo pim dm to disable PIM-DM.
By default, PIM-DM is disabled.
This command can take effect only after IP multicast routing is enabled.
PIM-DM cannot be used for multicast groups in the SSM group range.
Related commands: multicast routing-enable, pim sm, and ssm-policy.
Examples
# Enable IP multicast routing, and enable PIM-DM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast routing-enable
125
Advertisement
Table of Contents
