Timer Retry - HP 6125G Command Reference Manual
Ip multicast
Hide thumbs
Also See for 6125G:
- Command reference manual (410 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Default level
2: System level
Parameters
peer-address: MSDP peer address.
rp-policy ip-prefix-name: Specifies a filtering policy based on the RP address in SA messages, where
ip-prefix-name is the filtering policy name, a case-sensitive string of 1 to 19 characters.
Description
Use static-rpf-peer to configure a static RPF peer.
Use undo static-rpf-peer to remove a static RPF peer.
No static RPF peer is configured by default.
When you configure multiple static RPF peers, observe the follow rules:
If you use the rp-policy keyword for all the static RPF peers, all the static RPF peers take effect
•
concurrently. SA messages are filtered according to the configured prefix list and only those SA
messages whose RP addresses pass the filtering are accepted. If multiple static RPF peers use the
same filtering policy at the same time, when a peer receives an SA message, it forwards the SA
message to the other peers.
If you use the rp-policy keyword for none of the static RPF peers, according to the configuration
•
sequence, only the first static RPF peer whose connection is in up state is activated, and all SA
messages from this peer are accepted but the SA messages from other static RPF peers are
discarded. When this active static RPF peer fails (for example, when the configuration is removed
or when the connection is torn down), still the first RPF peer whose connection is in up state is
selected as the activated RPF peer according to the configuration sequence.
Related commands: display msdp peer-status and ip prefix-list.
Examples
# Configure static RPF peers.
<Sysname> system-view
[Sysname] ip ip-prefix list1 permit 130.10.0.0 16 great-equal 16 less-equal 32
[Sysname] msdp
[Sysname-msdp] peer 130.10.7.6 connect-interface vlan-interface 100
[Sysname-msdp] static-rpf-peer 130.10.7.6 rp-policy list1
timer retry
Syntax
timer retry interval
undo timer retry
View
MSDP view
Default level
2: System level
Parameters
interval: Interval between MSDP peer connection retries, in seconds. The value ranges from 1 to 60.
163
Advertisement
Table of Contents
