Overflow-Replace (Mld-Snooping View) - HP 6125G Command Reference Manual

Parameters
version-number: Specifies an MLD snooping version. The value can be 1 or 2.
Description
Use mld-snooping version to configure the MLD snooping version.
Use undo mld-snooping version to restore the default.
By default, the MLDv1 snooping is used.
This command can take effect only if MLD snooping is enabled for the VLAN, and it does not take effect
in a sub-VLAN of an IPv6 multicast VLAN.
Related commands: mld-snooping enable and subvlan.
Examples
# Enable MLD snooping in VLAN 2, and specify MLDv2 snooping.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2

overflow-replace (MLD-snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
MLD-snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094. If you do not specify any VLAN, the command applies to all VLANs. If you specify one
or multiple VLANs, the command applies to the specified VLANs only.
Description
Use overflow-replace to enable the IPv6 multicast group replacement function globally.
Use undo overflow-replace to disable the IPv6 multicast group replacement function globally.
By default, the IPv6 multicast group replacement function is disabled globally.
This command works in both MLD snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
Related commands: mld-snooping overflow-replace.
247