Multicast Ipv6 Boundary - HP 6125G Command Reference Manual

Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 56 Command output
Field
RPF interface
RPF neighbor
Referenced prefix/prefix length
Referenced route type
Route selection rule
Load splitting rule

multicast ipv6 boundary

Syntax
multicast ipv6 boundary { ipv6-group-address prefix-length | scope { scope-id | admin-local | global |
organization-local | site-local } }
undo multicast ipv6 boundary { ipv6-group-address prefix-length | scope { scope-id | admin-local |
global | organization-local | site-local } | all }
View
Interface view
Default level
2: System level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group address, in the range of FFxy::/16, where x and
y represent any hexadecimal number from 0 through F.
prefix-length: Specifies the Prefix length of an IPv6 multicast group address, in the range of 8 to 128.
scope-id: Specifies the ID of an admin-scope zone in the range of 3 to 15, which is identified by the
scope field in the IPv6 multicast group address,.
admin-local: Specifies the scope zone as admin-local, which has a scope ID of 4.
global: Specifies the scope zone as global, which has a scope ID of 14.
organization-local: Specifies the scope zone as organization-local, which has a scope ID of 8.
Description
Interface type and number of the RPF interface.
IPv6 address of the RPF neighbor.
Referenced route and prefix length.
Type of the referenced route, which can be any of the
following:
•
igp—IPv6 unicast route (IGB).
•
egp—IPv6 unicast (EGP).
•
unicast (direct)—IPv6 unicast route (directly connected).
•
unicast—Other IPv6 unicast route (such as IPv6 unicast
static route).
•
mbgp—IPv6 MBGP route.
RPF route selection rule: An RPF route can be selected by the
priority of the routing protocol or by the longest match of the
destination address in the routing table.
Load sharing rule.
261