Igmp-Snooping Leave Source-Ip - HP 6125G Command Reference Manual

Related commands: igmp-snooping enable and last-member-query-interval.
Examples
# Enable IGMP snooping and set the IGMP last-member query interval to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping last-member-query-interval 3

igmp-snooping leave source-ip

Syntax
igmp-snooping leave source-ip { ip-address | current-interface }
undo igmp-snooping leave source-ip
View
VLAN view
Default level
2: System level
Parameters
ip-address: Specifies a source address for the IGMP leave messages that the IGMP snooping proxy sends,
which can be any legal IP address.
current-interface: Specifies the IP address of the current VLAN interface as the source address of IGMP
leave messages that the IGMP snooping proxy sends. If no IP address has been assigned to the current
VLAN interface, the default IP address 0.0.0.0 is used.
Description
Use igmp-snooping leave source-ip to configure the source IP address of the IGMP leave messages that
the IGMP snooping proxy sends.
Use undo igmp-snooping leave source-ip to restore the default.
By default, the source IP address of the IGMP leave messages that the IGMP snooping proxy sends is
0.0.0.0.
Before you configure this command in a VLAN, enable IGMP snooping in the VLAN.
The source IP address configured in the igmp-snooping leave source-ip command also applies when the
simulated host sends IGMP leave messages.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP snooping in VLAN 2 and configure the source IP address of IGMP leave messages that
the IGMP snooping proxy sends in VLAN 2 to 10.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
20