Atz Set All Current Parameters To User Defined Profile - Siemens TC63 Command Set

TC63 AT Command Set
2.8 ATZ
2.8

ATZ Set all current parameters to user defined profile

sets all current parameters to the user profile stored with AT&W. If a connection is in progress, it will be ter-
ATZ
minated.
All defined GPRS contexts which are not activated or not online will be undefined (see AT+CGDCONT,
and
AT+CGQREQ AT+CGQMIN
The user defined profile is stored to the non-volatile memory.
Syntax
Exec Command
ATZ[<value>]
Response(s)
OK
Reference(s)
V.250
Parameter Description
(num)
<value>
[0]
Notes
• First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this
profile will be loaded afterwards.
• Any additional commands on the same command line may be ignored. A delay of 300 ms is required before
next command is sent, otherwise "OK" response may be corrupted.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
command).
PIN
!
Reset to user profile
Page 39 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
s
Last
% % ! % !
5/24/05