At+Fclass Fax: Select, Read Or Test Service Class - Siemens TC63 Command Set

TC63 AT Command Set
12.2 AT+FCLASS
12.2

AT+FCLASS Fax: Select, read or test service class

sets the ME to a particular mode of operation (data, fax). This allows the ME to process information
AT+FCLASS
in a manner suitable for that type of information.
Syntax
Test Command
AT+FCLASS=?
Response(s)
(list of supported <n>s)
OK
Read Command
AT+FCLASS?
Response(s)
<n>
OK
Write Command
AT+FCLASS=<n>
Response(s)
OK
Reference(s)
EIA/TIA-592-A
Parameter Description
(num)(&W)(&V)
<n>
(&F)
[0]
1
Notes
• Using Error Correcting Mode (ECM) when sending FAXes over GSM should be avoided.
• If is set to 1, all incoming calls will be answered as fax calls when
<n>
1 resp. ASC0. For calls explicitly signaled as voice or data calls, this procedure will fail with result code "NO
CARRIER", but the incoming call will continue to ring.
It is possible to change the setting of
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN
!
Data (e.g. EIA/TIA-602 or ITU V.250)
Fax class 1 (EIA/TIA-578-A, Service Class 1)
to 0 while the call is ringing, and accept the call afterwards with ATA.
<n>
Page 312 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% ! % %
is issued on multiplexer channel
ATA
s
Last
! ! ! % !
5/24/05