Siemens TC63 Command Set page 394

TC63 AT Command Set
17.3 AT+CPBR
(num)
<type>
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also
AT+CPBW.
Possible values are:
145
161
209
255
129
(str)(+CSCS)
<text>
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter <tlength>.
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.5,
(num)
<maxloc>
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
(num)
<nlength>
Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-
tions with extended memory is available per phonebook. These locations allow storing numbers with twice the
standard length, which is
saved with <type>=209.
(num)
<tlength>
Maximum length of
<text>
given in octets. If
<text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to GSM 11.11, Annex B [23]. In the worst case the number of UCS2 characters is at
least one less than half the number of GSM characters.
Note
• can be used only after the phonebook data from the SIM have been read successfully for the first
AT+CPBR
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the initial read process is in progress, an attempt to use any of the phone-
book commands will result in "+CME Error: 14" (SIM busy).
We recommend to take advantage of the
the user when SIM data are accessible after SIM PIN authentication. The URC will be delivered once the ME
has completed reading data from the SIM card.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Dialing string
<number>
National number. Network support of this type is optional.
Dialing string
<number>
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
Dialing string
<number>
i.e. "*", "#" codes are contained. Network support of this type is optional.
Otherwise
Supported character
2*<nlength> digits for normal numbers, but only
assigned to the telephone number. The value indicated by the test command is
is given as GSM characters each character corresponds to one octet. If the
"^SSIM
Page 394 of 501
includes international access code character '+'
has been saved as ASCII string and includes non-
is a command to control a Supplementary Service,
sets.
READY" URC. If enabled with AT^SSET, this URC notifies
s
is, depending
ATD><mem><n>
<type>
digits for numbers
<nlength>
<text>
5/24/05
of