TC63 AT Command Set
11.20 ATH
11.20
ATH Manual rejection of a network request for PDP context acti-
vation
The V.250
command may be used to deactivate all PDP contexts which are active or online on the same
ATH
interface. This command should not be used to deactivate PDP contexts during the implicit PDP context deacti-
vation procedure which is started automatically after LCP termination or by dropping the DTR line (if AT&D2 is
configured). For details refer to Section 11.5.1,
The
command may also be used to reject a network request for PDP context activation announced by the
ATH
unsolicited result codes "RING: GPRS" or "+CRING: GPRS".
Syntax
Exec Command
ATH
Response(s)
OK
Reference(s)
GSM 07.07
Notes
•
In contrast to GSM 07.07 it is possible to cancel a connection with
patibility reasons due to the "dial-up network" drivers of Microsoft Windows.
•
is used as a standard V.250 AT command, too.
ATH
•
If
is used to reject a network request for PDP context activation, then other PDP contexts on the same
ATH
interface which are active or online will not be deactivated.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Automatic deactivation of PDP context during dial-up
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
%
%
§
%
ATH
Page 306 of 501
s
%
§
§
!
after a break. This is done for com-
PPP.
Last
!
!
5/24/05