Siemens TC63 Command Set page 61

TC63 AT Command Set
2.14 AT^SCFG
(str)(+CSCS)
<ropr>
Radio Output Power Reduction
According to 3GPP Rel99, output power reduction for multiple TX slots is a mandatory feature. The amount of
power reduction is configurable up to 3.0dB for 2TX, 4.8dB for 3Tx to 6dB for 4TX. To optimize heat dissipation,
power consumption and SAR values it is recommended to use full power reduction (value "3").
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
"1"
"2"
(P)
"3"
(str)(+CSCS)
<succ>
CIEV Call Status Indication
This parameter can be used to control the behaviour of URC "+CIEV: call". See also AT+CIND,
Section 7.1, Call Status
Parameter is global for all interfaces and will not be reset by AT&F.
(P)
"restricted"
"verbose"
(str)(+CSCS)
<sucs>
SLCC Call Status Indication
This parameter can be used to control the behaviour of URC "^SLCC". See also
Status Information.
Parameter is global for all interfaces and will not be reset by AT&F.
"restricted"
(P)
"verbose"
(str)(+CSCS)
<uri>
URC RING line
This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces
and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator
for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (<groid>).
Parameter is local for the interface, volatile and will not be reset by AT&F.
"off"
(P)
"local"
"asc0"
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Medium Reduction at GMSK (0dB for 1TX and 2TX, 1.8dB for 3TX and 3dB
reduction 4TX
Medium Reduction at GMSK (1TX 0dB, 2TX 3dB, 3TX 4.8dB and 4TX 6dB
reduction)
Maximal Reduction at GMSK (1TX 0dB, 2TX 3dB, 3TX 4.8dB and 4TX 6dB
reduction)
Information.
URC "+CIEV: call" will be issued only when a Call Status transition ends in
state "active" or "unknown" (see Section 7.1,
in the list of active calls.
URC "+CIEV: call" will be issued when any state transition (including transi-
tions beginning or ending in state "unknown") occurs in the list of active calls,
or when a traffic channel is established.
URC "^SLCC" will be issued only when a Call Status transition ends in state
"active" or "unknown" (see Section 7.1,
list of active calls
URC "^SLCC" will be issued when any state transition (including transitions
beginning or ending in state "unknown") occurs in the list of active calls, or
when a traffic channel is established.
URC is not indicated by RING.
URC will be indicated by an activated RING line of the interface on which the
URC appears
URC is indicated by an activated RING0 line.
Page 61 of 501
s
Call Status Information) for a call
and Section 7.1,
AT^SLCC
Call Status Information) for a call in the
and
AT+CMER
Call
5/24/05