Siemens TC63 Command Set page 239

TC63 AT Command Set
10.1 AT^SICS
"dns2"
(str)
<conParmValue>
Parameter value; type and supported content depend on related <conParmTag>.
<conParmValue-conType>
Supported connection type values in
"CSD"
"GPRS0"
"none"
<conParmValue-alphabet>
Character set selectable with
["0"]
"1"
<conParmValue-dataRate>
Supported data rate values in
"0"
["1"]
<conParmValue-dataType>
Supported data call type values in
"0"
["1"]
TC63_ATC_V00.490
Confidential / Draft - Do not copy
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.
The default value applies automatically if no other address is set. Note that the
read command only returns a manually configured IP address, while
AT^SICS
the value "0.0.0.0" is not indicated at all, no matter whether assumed by default
or explicitly specified.
Secondary DNS server address (IP address in dotted-four-byte format).
If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be
used to manually configure an alternate server for the DNS1.
If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then
"dns2"="0.0.0.0" will be assumed automatically. The
only returns a manually configured IP address, while the value "0.0.0.0" is not
indicated at all, no matter whether assumed by default or explicitly specified.
(str)
<conParmValue>
Circuit-switched data call.
GPRS connection.
Settings of GPRS related commands are not used, e.g. AT+CGDCONT. When a
service based on a GPRS connection profile is started after entering
TC63 automatically tries to attach to the GPRS. Yet, the only exception is
which can be used any time to detach from the GPRS and, and thus
AT+CGATT
disconnect the bearer opened with AT^SISO.
Clears the connection profile.
(str)
for
<conParmValue> <conParmTag>
Character set determined with
International Reference Alphabet (IRA, seven bit ASCII) applies.
(str)
for
<conParmValue> <conParmTag>
14.4 KBaud
9.6 KBaud
(str)
<conParmValue>
ISDN
Analog
Page 239 of 501
for value "conType".
<conParmTag>
value "alphabet".
applies.
AT+CSCS
value "dataRate".
for value "dataType".
<conParmTag>
s
read command
AT^SICS
AT^SISO
5/24/05