At^siso Internet Service Open - Siemens TC63 Command Set

TC63 AT Command Set
10.3 AT^SISO
10.3

AT^SISO Internet Service Open

The write command starts the Internet session configured by the service profile. If the service opens
AT^SISO
successfully, the URCs "^SISW" and "^SISR" will trigger the action to follow, either writing data with
or reading data with AT^SISR. If the "^SISW" and "^SISR" URCs notify that no data are available at all, or that
a data transfer has been successful, the service can be closed with AT^SISC. If an error occurs after opening or
while using a service then the URC type "^SIS" described below will be delivered.
In any case, an opened service must be finished by sending the Close command AT^SISC. This applies no mat-
ter whether the service has been completed successfully (all data transmitted) or entered an error state (e.g. indi-
cated by the "^SIS" URC). It is also necessary when a service, such as POP3 or FTP, has already closed
automatically after successful data transfer and entered
The read command requests the status of all Internet service profiles. One line is issued for every Inter-
AT^SISO
net service profile. Information following the
given a valid value via AT^SISS. The read command can be used any time during operation or after closing a
service. In the latter case the response indicates the state of the last event related to a specific service profile. It
will be updated only when the same service profile is used again.
Syntax
Test Command
AT^SISO=?
Response(s)
OK
Read Command
AT^SISO?
Response(s)
^SISO: <srvProfileId>, <srvParmTag>value "srvType" [, <srvState>, <socketState>,
<rxCount>, <txCount>, <locAddr>, <remAddr>]
OK
Write Command
AT^SISO=<srvProfileId>
Response(s)
OK
ERROR
+CME ERROR: <err>
Unsolicited Result Code
Indicates the current state of the Internet service.
^SIS: <srvProfileId>, <urcCause>[, [<urcInfoId>][, <urcInfoText>]]
The URC may appear if an error occurs, for example after opening an Internet service with
during operation. The URC also indicates a request for a mobile terminated Internet service client connection, or
a failure if a mobile terminated request is rejected. Furthermore, the URC may deliver an information element
resulting from a specific command given in the service profile.
The precise
<urcInfoText>
nario and the implementation of the remote server. A list of possible causes can be found in Section 10.7,
mation Elements Related to Internet Service
TC63_ATC_V00.490
Confidential / Draft - Do not copy
<srvParmTag>
PIN
§
related to a
<urcInfoId>
URCs.
Page 254 of 501
"2".
<srvState>
value "srvType" is issued only, if "srvType" was
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
varies greatly depending on the used service, the sce-
s
AT^SISW
Last
% % ! ! !
or any time
AT^SISO
Infor-
5/24/05