Siemens TC63 Command Set page 429

TC63 AT Command Set
18.15 AT^SNFS
Notes
• The write command can be used during a voice call to switch back and forth between different modes. This
allows the user, for example, to switch handsfree operation (speakerphone) on and off.
• Users should be aware that
during a call, the value of
with or AT+CMUT: If the microphone is muted and the user selects another audio mode during the
AT^SNFM
call, then the microphone remains muted until explicitly changed. Exception: In audio mode 1 <outStep>=4
is fix.
• For use after restart of the module, you are advised to store the selected mode to the audio profile saved with
AT^SNFW. Otherwise, audio mode 1 will be active each time the module is powered up.
Examples
EXAMPLE 1
Suppose a user wishes to use alternatively a handsfree device (speakerphone) and a handset. The handset
can be connected to the first analog interface and adjusted to audio mode 4. The handsfree device can be
attached to the second analog interface and adjusted to audio mode 2. The factory defaults of
not be changed.
Settings for the handset:
AT^SNFS=4
OK
AT^SAIC?
^SAIC: 2,1,1
OK
Settings for the handsfree device:
AT^SNFS=2
OK
AT^SAIC?
^SAIC: 2,2,2
OK
To store the configuration to the user defined audio profile:
AT^SNFW
OK
To switch back and forth:
AT^SNFS=4
OK
AT^SNFS=2
OK
EXAMPLE 2
The following example illustrates a combination of a handset and a handsfree device connected to other inter-
faces than those assumed as factory default.
Settings for a handset connected to the second analog interface and adjusted to audio mode 4:
AT^SNFS=4
OK
AT^SAIC=2,2,2
OK
Settings for a handsfree device connected to the first analog interface and adjusted to audio mode 2:
AT^SNFS=2
OK
AT^SAIC=2,1,1
OK
To store the configuration to the user defined audio profile:
TC63_ATC_V00.490
Confidential / Draft - Do not copy
is a global setting. This means, when another audio mode is selected
<outStep>
does not change. This is also true for mute operation which can be set
<outStep>
Factory default of AT^SAIC assigned to audio mode 4.
Factory default of AT^SAIC assigned to audio mode 2.
Stores the audio mode and the interface.
Switches to the handset connected to analog interface 1.
Switches to the handsfree device at analog interface 2.
Page 429 of 501
s
need
AT^SAIC
5/24/05