At^snfv Set Loudspeaker Volume - Siemens TC63 Command Set

TC63 AT Command Set
18.17 AT^SNFV
18.17

AT^SNFV Set loudspeaker volume

can be used to set the volume of the loudspeaker to the value
AT^SNFV
Step>. The read and write commands refer to the active audio mode. The write command works only in audio
modes 2 to 6.
Syntax
Test Command
AT^SNFV=?
Response(s)
^SNFV: (list of supported <outStep>s)
OK
Read Command
AT^SNFV?
Response(s)
^SNFV: <outStep>
OK
Write Command
AT^SNFV=<outStep>
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
SIEMENS
Parameter Description
(num)
<outStep>
The actual volume of each step is defined by the parameter <outCalibrate>, which can be set with AT^SNFO.
(P)
0...4
Notes
• Any change to
<outStep>
then select another mode with AT^SNFS, the same step will be applied. Nevertheless, the actual volume can
be quite different, depending on the values of
audio mode 1 which is fixed to <outStep>=4.
• is stored non-volatile when the ME is powered down with
<outStep>
is not stored by AT^SNFW.
<outStep>
• can also be changed by
<outStep>
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN
!
takes effect in audio modes 2 to 6. That is, when you change
<outCalibrate>
(Section 18.13) and
AT^SNFO
Page 432 of 501
<outCalibrate>
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
set in each mode. The only exception is
AT^SMSO
(Section 18.4).
AT+CLVL
s
addressed by
<out-
Last
% % ! % !
and
<outStep>
or reset with AT+CFUN=1,1.
5/24/05