At+Cind Indicator Control - Siemens TC63 Command Set

TC63 AT Command Set
3.2 AT+CIND
3.2

AT+CIND Indicator control

The command controls the presentation of Indicator Event Reports related to various functions such
AT+CIND
as battery charge level, signal quality, service availability, sound generation, indication of unread short mes-
sages, full SMS storage, call in progress or roaming activities.
Use of has become outdated. Rather we recommend the more powerful
AT+CIND
easier to use and provides additional indicators. All indicators provided by
as well.
AT^SIND
supports two ways to get the values related to indicators:
AT+CIND
• One approach is to query the current status of each indicator by using the read command AT+CIND?. It
returns the status no matter whether the indicator has been registered with the write command
AT+CIND=[<mode>[,<mode>[,...]]].
• The other way is an event-driven notification based on the "+CIEV" URCs. In this case, the ME will automat-
ically send a message to the application, whenever the value of an indicator changes. The application should
be designed to react adequately when receiving a URC.
The presentation of these URCs depends on two settings:
- The indicators must be registered with the write command AT+CIND=[<mode>[,<mode>[,...]]]. When the
ME is switched on all of them are in registered mode. Any indicator can be excluded if deregistered with
<mode>=0. To register or deregister an indicator the
<mode>=1 or 0 exactly at the position where the indicator is located in the list. This is not necessary with
which allows to specify indicators by name. See examples below.
AT^SIND
- The presentation of the registered indicators must be enabled with AT+CMER.
Syntax
Test Command
AT+CIND=?
Response(s)
+CIND: (<indDescr>, list of supported <indValue>s)[, (<indDescr>, list of supported <indValue>s)[,
...]]
OK
Read Command
AT+CIND?
Response(s)
+CIND: <indValue>[, <indValue>[, ...]]
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CIND=<mode>[, <mode>[, ...]]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s)
GSM 07.07
Parameter Description
(num)
<indValue>
Integer type value, which shall be in range of corresponding
TC63_ATC_V00.490
Confidential / Draft - Do not copy
write command requires to type the value
AT+CIND
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
! % % %
<indDescr>
Page 68 of 501
s
command which is
AT^SIND
can be handled with
AT+CIND
% % % !
Last
% !
5/24/05