At+Csns Single Numbering Scheme - Siemens TC63 Command Set

TC63 AT Command Set
7.25 AT+CSNS
7.25

AT+CSNS Single Numbering Scheme

Syntax
Test Command
AT+CSNS=?
Response(s)
+CSNS: (list of supported<mode>s)
OK
Read Command
AT+CSNS?
Response(s)
+CSNS: <mode>
OK
Write Command
AT+CSNS=[<mode>]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
GSM 07.07
Command Description
The command enables the ME to accept incoming calls when no bearer capability information is pro-
AT+CSNS
vided with the call, e.g. single numbering scheme calls or calls originitating from analog devices.
Parameter Description
(num)
<mode>
(D)
[0]
2
4
Notes
• The command must be set before the call comes. By default, when you do not modify the settings, all calls
received without bearer element are assumed to be voice.
• The setting will be automatically saved when you power down the GSM engine with AT^SMSO, provided that
PIN authentication has been done. This value will be restored when PIN authentication is done again.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN
!
Voice: Each call received without bearer element is assumed to be speech
Fax: Each call received withoutbearer element is assumed to be an incoming
fax.
Data: Each call received without bearer element is assumed to be a data call.
Please take into account that the bearer service parameters set with
apply to all data calls including those received without bearer capability.
Page 174 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % % %
s
Last
% % ! % !
AT+CBST
5/24/05