At+Icf Serial Interface Character Framing - Siemens TC63 Command Set

TC63 AT Command Set
4.6 AT+ICF
4.6

AT+ICF Serial Interface Character Framing

The command controls the serial interface character framing format and parity used for receiving and
AT+ICF
transmitting.
The following settings are supported:
• 7 bits, even parity, 1 stop bit (AT+ICF=5,1)
• 7 bits, odd parity, 1 stop bit (AT+ICF=5,0)
• 8 bits, even parity, 1 stop bit (AT+ICF=2,1)
• 8 bits, no parity, 1 stop bit (AT+ICF=3)
• 8 bits, odd parity, 1 stop bit (AT+ICF=2,0)
• 8 bits, no parity, 2 stop bits (AT+ICF=1)
Syntax
Test Command
AT+ICF=?
Response(s)
+ICF: (list of supported <format>s), (list of supported <parity>s)
OK
Read Command
AT+ICF?
Response(s)
+ICF: <format>[, <parity>]
OK
Write Command
AT+ICF=[<format>][, <parity>]
Response(s)
OK
ERROR
Reference(s)
V.250
Parameter Description
(num)(&W)(&V)
<format>
Specifies the character format used for receiving and transmitting.
1
2
[3]
5
(num)(&W)(&V)
<parity>
Specifies the method of calculating the parity bit, if a parity bit is supported by <format>.
If does not support parity, this parameter has to be omitted.
<format>
0
1
TC63_ATC_V00.490
Confidential / Draft - Do not copy
PIN
!
8 data 0 parity 2 stop
8 data 1 parity 1 stop
8 data 0 parity 1 stop
7 data 1 parity 1 stop
odd
even
Page 94 of 501
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
% % ! §
s
Last
§ § ! % !
5/24/05