Siemens TC63 Command Set page 120

TC63 AT Command Set
5.4 AT+CLCK
Supplementary Service Call Barring:
Supplementary Service "Call Barring" allows to specify conditions under which calls will be disallowed by the
network.
The availability of the Supplementary Services varies with the network. To benefit from call barring the client will
need to subscribe them, though a limited number of call barring types may be included in the basic tariff pack-
age.
When you attempt to set a
ported by the module, the setting will not take effect regardless of the response returned. The responses in these
cases vary with the network (for example "OK", "+CME ERROR: Operation not allowed", "+CME ERROR: Oper-
ation not supported" etc.). To make sure check the extended error response with
with <mode>=2.
<password>: Network password supplied from the provider or operator. Usually there is one password which
applies to all call barring options. For details contact your provider.
"AO"
"OI"
"OX"
"AI"
"IR"
"AB"
"AG"
"AC"
(num)
<mode>
0
1
2
(num)
<status>
0
1
(str)
<password>
Password string used to lock and to unlock a <facility>. Length and authority for passwords depend on the
in question and are therefore listed in the section on parameter <facility>. Passwords can be
<facility>
modified with
AT+CPWD
(num)
<class>
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04".
1
2
4
8
16
32
TC63_ATC_V00.490
Confidential / Draft - Do not copy
or
<facility> <class>
BAOC (Bar All Outgoing Calls)
BOIC (Bar Outgoing International Calls)
BOIC-exHC (Bar Outgoing International Calls except to Home Country)
BAIC (Bar All Incoming Calls)
BIC-Roam (Bar Incoming Calls when Roaming outside the home country)
All Barring services (applicable only for <mode>=0)
All outGoing barring services (applicable only for <mode>=0)
All inComing barring services (applicable only for <mode>=0)
unlock
lock
query status
lock is inactive
lock is active
or AT^SPWD.
voice
class 2 ("data") comprises all those individual data classes between 16 and
128, that are supported both by the network and the MS. This means, a setting
made for class 2 applies to all individual data classes (if supported). In addition,
you can assign a different setting to a specific class. For example, you can acti-
vate Call Forwarding for all data classes, but deactivate it for data class 64,
"dedicated packet access".
fax
SMS
data circuit sync
data circuit async
Page 120 of 501
which is not provisioned, not yet subscribed to, or not sup-
s
and the lock status
AT+CEER
5/24/05