Siemens TC63 Command Set page 67

TC63 AT Command Set
3.1 AT+CMER
Parameter Description
(num)
<mode>
(&F)
0
1
2
3
(num)
<keyp>
(&F)
0
(num)
<disp>
(&F)
0
(num)
<ind>
(&F)
0
2
(num)
<bfr>
(&F)
0
(str)
<indDescr>
Name of indicator; for a list of all supported indicators please refer to
(num)
<indValue>
Value of indicator; for a list of all values for the supported indicators please refer to
Note
• If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0/ASC1) avoid different settings for
routing and indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set
with AT+CNMI, AT^SSDA), it is not possible to activate the presentation of URCs with
on another instance. Any attempt to activate settings that conflict with existing settings on another interface,
will result in CME ERROR, or accordingly CMS ERROR.
TC63_ATC_V00.490
Confidential / Draft - Do not copy
Discard "+CIEV" and "^SLCC" URCs.
Discard "+CIEV" and "^SLCC" URCs when TA-TE link is reserved, e.g. in
online data mode. Otherwise they are forwarded directly to the TE.
Buffer "+CIEV" and "^SLCC" URCs in the TA while TA-TE link is reserved, e.g.
in online data mode, and flush them to the TE afterwards. Otherwise they are
forwarded directly to the TE.
Forward "+CIEV" and "^SLCC" URCs directly to the TE. If TC63 is in online
data mode, URCs are signaled via sending BREAK (100ms) and stored in a
buffer. Once it is back in command mode e.g. after
stored in the buffer will be output.
Keypad event reporting is not supported by TC63.
Display event reporting is not supported by TC63.
Disable indicator event reporting.
Enable indicator event reporting.
TA buffer of URCs defined within this command is cleared when
is entered.
Page 67 of 501
s
was entered, all URCs
+++
and AT^SIND.
AT+CIND
and AT^SIND.
AT+CIND
AT+CMER
1..3
<mode>
or
AT+CNMI
5/24/05